236 ft of White Seamless Gutter on a 1920s Atlanta Bungalow
Atlanta, GA
We replaced the gutter system on a 1920s Craftsman bungalow in Atlanta’s 30317 ZIP, a house whose rooflines wrap around a back courtyard, with a guest house (ADU) on the same lot. The old gutters came down, and we formed 236 feet of new 6-inch K-style gutter on site in white and hung it in the same spots, with new white 3×4 downspouts on the front and left side of the house.
A roofline full of corners
This bungalow’s rooflines meet at angle after angle, around the courtyard and along each wing, so the new system needed 13 mitered corners and only three end caps. In six spots a roof valley or a steep pitch sends water into the gutter hard enough to shoot over the front edge in a heavy rain. One stretch of fascia at the back right had rotted. And on the guest house, the old gutter had been hung too high, with its back edge above the roof’s drip edge instead of under it, which lets water get in behind the gutter.
New white gutters, and a fix on the guest house
We took down 236 feet of old gutter, formed 236 feet of 6-inch K-style aluminum in white on site and hung it on 158 hidden hangers. We cut and sealed 13 miters at the corners, set six oval outlets, and added six splash guards where the valleys and steep pitches meet the gutter. We replaced 16 feet of rotted fascia at the back right with primed pine before the gutter went back up. The 50 feet of new 3×4 downspout runs down the front and left side, with 14 elbows and 12 pipe bands, and every seam is sealed with tripolymer gutter sealant. On the guest house we cleaned the gutters by hand and flushed the downspouts, lowered the existing gutter and re-hung it under the drip edge, then covered all 47 feet with white High Flow Helmet guards (.024 aluminum with 3/16-inch holes).
Highlights
- 236 ft of 6-inch seamless
- 13 mitered corners
- 16 ft of new fascia
- Helmet guards on the guest house